Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 3 de 3
Filtrar
Mais filtros










Base de dados
Intervalo de ano de publicação
1.
Rev Sci Instrum ; 95(4)2024 Apr 01.
Artigo em Inglês | MEDLINE | ID: mdl-38629928

RESUMO

The dynamic diamond anvil cell (dDAC) is a recently developed experimental platform that has shown promise for studying the behavior of materials at strain rates ranging from intermediate to quasi-static and shock compression regimes. Combining dDAC with time-resolved x-ray diffraction (XRD) in the radial geometry (i.e., with incident x-rays perpendicular to the axis of compression) enables the study of material properties such as strength, texture evolution, and deformation mechanisms. This work describes a radial XRD dDAC setup at beamline P02.2 (Extreme Conditions Beamline) at DESY's PETRA III synchrotron. Time-resolved radial XRD data are collected for titanium, zirconium, and zircon samples, demonstrating the ability to study the strength and texture of materials at compression rates above 300 GPa/s. In addition, the simultaneous optical imaging of the DAC sample chamber is demonstrated. The ability to conduct simultaneous radial XRD and optical imaging provides the opportunity to characterize plastic strain and deviatoric strain rates in the DAC at intermediate rates, exploring the strength and deformation mechanisms of materials in this regime.

2.
J Phys Condens Matter ; 34(5)2021 Nov 12.
Artigo em Inglês | MEDLINE | ID: mdl-34706344

RESUMO

Hafnium (Hf) is an industrially important material due to its large neutron absorption cross-section and its high corrosion resistance. When subjected to high pressure, Hf phase transforms from its hexagonal close packed α-Hf phase to the hexagonal ω-Hf phase. Upon further compression, ω-Hf phase transforms to the body centered cubic ß-Hf phase. In this study, the high pressure phase transformations of Hf are studied by compressing and decompressing a well-characterized Hf sample in diamond anvil cells up to 120 GPa while collecting x-ray diffraction data. The phase transformations of Hf were compared in both a He pressure transmitting medium (PTM) and no PTM over several experiments. It was found that the α-Hf to ω-Hf phase transition occurs at a higher pressure during compression and lower pressure during decompression with a helium (He) PTM compared to using no PTM. There was little difference in the ω-Hf to ß-Hf phase transition pressure between the He PTM and no PTM. The equation of state was fit for all three phases of Hf and under both PTM and no-PTM.

3.
Sci Rep ; 7(1): 4027, 2017 06 22.
Artigo em Inglês | MEDLINE | ID: mdl-28642619

RESUMO

Strong anisotropic compression with pressure on the remarkable non-linear optical material KBe2BO3F2 has been observed with the linear compression coefficient along the c axis found to be about 40 times larger than that along the a axis. An unusual non-monotonic pressure response was observed for the a lattice parameter. The derived bulk modulus of 31 ± 1 GPa indicates that KBe2BO3F2 is a very soft oxide material yet with stable structure up to 45 GPa. A combination of high-pressure synchrotron powder X-ray diffraction, high-pressure Raman spectroscopy, and Density Functional Theory calculations points to the mechanism for the unusual pressure response being due to the competition between the K-F bond length and K-F-K bond angle and the coupling between the stretching and twisting vibration modes.

SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA
...